Adsorption of phosphate over a novel magnesium-loaded sludge-based biochar.

The production of sludge-based biochar to recover phosphorus (P) from wastewater and reuse the recovered phosphorus as agricultural fertilizer is a preferred process. This article mainly studied the removal of phosphate (PO4-P) from aqueous solution by synthesizing sludge-based biochar (MgSBC-0.1) from anaerobic fermentation sludge treated with magnesium (Mg)-loading-modification, and compared it with unmodified sludge-based biochar (SBC). The physicochemical properties, adsorption efficiency, and adsorption mechanism of MgSBC-0.1 were studied. The results showed that the surface area of MgSBC-0.1 synthesized increased by 5.57 times. The material surface contained MgO, Mg(OH)2, and CaO nanoparticles. MgSBC-0.1 can effectively remove phosphate in the initial solution pH range of 3.00-7.00, with a fitted maximum phosphorus adsorption capacity of 379.52 mg·g-1. The adsorption conforms to the pseudo second-order kinetics model and Langmuir isotherm adsorption curve. The characterization of the adsorbed composite material revealed the contribution of phosphorus crystal deposition and electrostatic attraction to phosphorus absorption.

Efficiency and mechanism of phosphate adsorption and desorption of a novel Mg-loaded biochar material.

Phosphate removal is complicated by the need for resource recovery. Biochar shows promise for efficient phosphate adsorption, but it must be modified to enhance its adsorption capacity. In this work, magnesium (Mg)-loaded biochar was synthesized through a two-step dipping and calcination process, and the MgBC600 product was used to adsorb phosphate from simulated water and biogas slurry wastewater. The phosphate adsorption capacity of Mg-loaded biochar was 109.35 mg/g, which was 12 times higher than that of unmodified biochar. The R2 of the Langmuir and pseudo-second-order kinetic models were 0.988 and 0.990, respectively, which fitted the phosphate adsorption process of MgBC600. Phosphate adsorption by MgBC600 was a spontaneous and endothermic process. The adsorption mechanism study showed that phosphate adsorption was controlled by the formation and electrostatic attraction of MgHPO4. In addition, 98% of chemically adsorbed phosphate was released after regeneration. Using phosphate-adsorbed MgBC600 as a soil amendment, Arabidopsis thaliana was 1.47 times higher than that in the biochar-only group, demonstrating that this is a promising strategy for enhancing phosphate adsorption efficiency and adsorbent recycling.

Enhanced photocatalytic degradation of tetracycline hydrochloride over Au-doped BiOBr nanosheets under visible light irradiation.

Bismuth(III) oxybromide (BiOBr) is a typical photocatalyst with a unique layered structure. However, the response of BiOBr to visible light is not strong enough for practical application. Moreover, the charge separation efficiency of BiOBr still needs to be improved. In this study, series of Au-doped BiOBr photocatalysts was prepared through a facile one-step hydrothermal method. The as-prepared Au0.3-BiOBr nanosheets exhibited an excellent electrochemical performance. The charge separation efficiency of Au0.3-BiOBr nanosheets was enhanced by 18.5 times compared with that of BiOBr. The intrinsic photocatalytic activity of Au0.3-BiOBr nanosheets in the degradation of tetracycline hydrochloride was approximately twice higher than that of BiOBr under visible light irradiation. In addition, three pathways were identified for the photocatalytic degradation and mineralization of tetracycline hydrochloride, which involve four reactions: hydroxylation, demethylation, ring opening and mineralization. Accordingly, this study proposes a feasible and effective Au-doped BiOBr photocatalyst, and describes a promising strategy for the design and synthesis of high-performance photocatalysts.